Cd-technologies RS-2098 RDC Rack Manuel d'utilisateur télécharger pdf (Page 4)

ASSEMBLY INSTRUCTIONS FOR RDC STANDARD AND EP RACKS

7. EP Rack Assembly: Install all back restraint rail(s) and

cover(s). See Figure 7 and Detail E for hardware details.

Position front restraint rail and cover temporarily next to front

support rail prior to installing cells. See step 10 for information

on corner brackets.

If the battery row is shorter than the rack so that the end rail

falls within a frame, the corner bracket must be placed on the

side rail and slid within the frame (See Figure 10)

8. Cell Installation Procedure: Optional arrangement drawing

if ordered, should be reviewed for cell placement. If not

instructed otherwise, install cells starting at the center of the

bottom row and work out towards each end leaving a half

inch space between cells. For EP racks, use cell spacers

between cells as supplied (see Detail F). Do not use oil or

grease as lubricants. A small amount of water, unscented

talcum or Dow Corning III may be applied to the rail cover

to help reduce friction. For rows having an odd number of

batteries, the center of the rst battery installed will match

the center of the row. For rows having an even number of

batteries, a cell space will coincide with the center of the row.

Pay attention to polarities and terminal placement. Refer to

the battery’s Installation and Operating Instruction manual

(RS-1476) for more details. All cells mounted on seismic racks

should be pushed back against back restraint rail and cover.

Up to an 1/8” gap between the restraint rail and cell jar wall

is acceptable. Repeat this procedure for remaining steps and

tiers, working upward. See Figure 8.

FIGURE 7 FIGURE 8

DETAIL E

DETAIL F

Back Restraint

and Cover

Frame

3/8-16 Bolt,

Lock Washer and

Serrated Nut

Frame and Restraint Rail(s)

(Reverse View)

Battery Units

Front Restraint

Rail and Cover

(loose)

RS02098/0114/CD 4 www.cdtechno.com

Support Rail

and Cover

Rail to Frame

Connection

See Detail C

Optional Third

Rail

Support Rail Installation

Cell Spacer

1 2 3 4 5 6 7 8

Commentaires sur ces manuels

Pas de commentaire

Cd-technologies RS-2098 RDC Rack Manuel d'utilisateur Page 4

Commentaires sur ces manuels

Produits connexes et manuels pour Fournisseurs d'énergie Cd-technologies RS-2098 RDC Rack